Skip to main content

Moving from the original PinOne

Settings from the original PinOne​

The PinOne Ultra uses a different microcontroller and a different configuration format than the original PinOne, but you can still use your backup from the original PinOne to migrate to the new one. You should still do a few things after migrating to the Ultra:

  • The plunger is now read in millivolts (0-3300), so the plunger must be recalibrated with the calibration routine.
  • The accelerometer is a different chip, so the accelerometer must be recalibrated. See Accelerometer.
  • Steam mappings made for the original PinOne need to be created again from the Controller page.

Using the config tool​

The PinOne Ultra needs the newer version of the config tool from here (Windows) or the releases page. The original PinOne can continue to use its own version of the tool. The older config tool for firmware updates on original boards is still available here: Config Tool